Instruction: 

	Prepairing your machine
	According to slooping of your machine balance, for example: a plank. Put this under the side stand or the right bolt could be distort.
	Now push the fitting stand from the left side to right side of your machine between the front- and rear wheel. The pipe with the writing character has to show above.
	Now change to the right side and push the fitting, then push the bolt through the bush.
	Now you have to balance the fitting, that between the gear lever and the brake lever is enough air (place).
	Now you have to make a boring of a hole 3,5 mm in the middle of the bolt.
	After that you save it with a feather plug !!
	Now you have to balance your machine and bring down the pipe with the writing character, with your foot. Make oil on the bolt !

 

Instruction-Video